国产一区二区免费,翔田千里AV,无码电影,红杏亚洲影院一区二区三区,国产精品欧美激情

a. Requirements 1) University graduated major in Physics, Chemistry, mechanical engineering, Electronics engineering, material science, or equivalent 2) Min 3 years' experience in Discrete or Module semiconductor mold, trim and form process 3) Epoxy mold compound properties and its reliability failures knowledge 4) Trim/From mechanical design understanding against delamination, package crack and bent lead 5) JMP, Minitab DOE or other statistical analysis skill will get advantages 6) Be familiar with design, process FMEA, Control plan generation 7) In-depth knowledge of power electronic packages and processes 8) Fundamental understanding of package design and material properties 9) Knowledge of power packages processes 10) Understanding of semiconductor material properties and their influence on semiconductor device behavior 11) Able to understand thermo/mechanical simulation and JMP data analysis tools is strongly desired 12) Excellent interpersonal, verbal, and written English communication skills 13) Ability to demonstrate great attention to detail 14) Are a proven self-starter b. Job description 1) Responsible from design review of new products, participate Package and substrate(Lead frame and DBC) design review, optimize design, process characterization, generate related spec and work instruction, to be owner of qualification and customers samples to complete product qualification, initial training of operation 2) Lead potential failure modes review to define RPN into DFEMA and find counter measure to optimize design for yield, cost, quality, reliability, manufacturability, cycle time 3) Lead supplier to design required tools and jig such like mold die, trim/form dies, magazine, tubes, or tray 4) Characterize and generate report for mold , trim and from related failure modes and key parameters of output variables according to D/PFMEA 5) Optimize process recipe, parameters, tools, jigs to meet die attach cost, quality, yield, UPH, reliability, manufacturability to hands over to operation department 6) Validate design rule by process characterization 7) Generate process quality specs, recipe, D/PFMEA, Control plan, work instruction to train operation 8) Resolve technical issues from characterization, qualification, and customer samples 9) Owner of correspond process to meet required process success criteria 10) Generate new equipment PO spec leading cross functional team from operation and support department